1611A Melrose Drive, Suite 16

Vista, CA 92083 USA

EMERGENCY PHONE: 760-727-3982

PRODUCT: Power CoinsÔ ligatures - Glow in the Dark series

COMPOSITION: Polyurethane CAS# 037383-28-1 90%

Phosphorescent pigment 10%

(Zinc sulfide copper doped)

APPEARANCE: Pigmented coin shape.

ODOR: Odorless.

VAPOR PRESSURE: Not applicable.

VAPOR DENSITY: Not applicable.

BOILING POINT: Not applicable.

SOLUBILITY IN WATER: Insoluble.

SPECIFIC GRAVITY: 1.1 – 1.2

FLAMMABLE PROPERTIES

FLASH POINT: Not applicable.

METHOD USED: Not applicable.

FLAMMABILITY LIMITS

LFL: Not applicable.

UFL: Not applicable.

HAZARDOUS COMBUSTION PRODUCTS: Under fire conditions polymers decompose. The smoke may contain polymer fragments of varying compositions in addition to unidentified toxic and/ or irritating compounds. Hazardous combustion products may include are not limited to Carbon monoxide and Carbon dioxide and trace amounts of aromatic hydrocarbons and Hydrogen cyanide and Hydrogen sulfide gas on contact with moisture or acid.

OTHER FLAMMABILITY INFORMATION: Dense smoke is emitted when burned without sufficient oxygen.

FIRE FIGHTING INSTRUCTIONS: Keep people away. Isolate fire area and deny unnecessary entry. Cool surroundings with water to localize fire zone. Hand held carbon dioxide or dry chemical extinguishers may be used for small fires. Soak thoroughly with water to cool and prevent reignition.

PROTECTIVE EQUIPMENT FOR FIRE FIGHTERS: Wear positive-pressure self-contained breathing apparatus (SCBA) and protective fire fighting clothing (includes fire fighting helmet, coat, pants, boots and gloves). If protective equipment is not available or not used, fight fire from a protected location or safe distance.

CHEMICAL STABILITY: Thermally stable at typical use temperatures.

CONDITIONS TO AVOID: Avoid temperatures above 500F (260C).

INCOMPATABILITY WITH OTHER MATERIALS: None known.

HAZARDOUS DECOMPOSITION PRODUCTS: Hazardous decomposition products depend on temperature, air supply and the presence of other materials.

HAZARDOUS POLYMERIZATION: Will not occur.

EYE/FACE PROTECTION: Use safety glasses.

SKIN PROTECTION: For most conditions, no skin protection should be needed.

RESPIRATORY PROTECTION: For most conditions, no respiratory protection should be needed.

EXPOSURE GUIDELINES: None established.

EMERGENCY OVERVIEW

Pigmented coin shape part. Odorless. No significant immediate hazards for emergency response are known.

POTENTIAL HEALTH EFFECTS

EYE: Solid or dust may cause irritation or corneal injury due to mechanical action. Elevated temperatures may generate vapor levels sufficient to cause eye irritation.

SKIN: Essentially nonirritating to skin. Mechanical injury only. Skin absorption is unlikely due to physical properties. Molten material may burn skin.

INGESTION: Single dose oral toxicity is considered to be extremely low. No hazards anticipated from swallowing small amounts incidental to normal handling operations.

INHALATION: Dust may cause irritation to upper respiratory tract. At room temperature, exposure to vapors are unlikely due to physical properties.

SYSTEMIC (OTHER TARGET ORGAN) EFFECTS: No specific data; however, repeated exposures to the unheated material are not anticipated to cause any significant adverse reactions.

CANCER INFORMATION: No relevant information found.

TERATOLOGY (BIRTH DEFECTS): No relevant information found.

REPRODUCTIVE EFFECTS: No relevant information found.

EYES: Flush eyes with plenty of water.

SKIN: Wash off in flowing water or shower.

INGESTION: No adverse effects anticipated by this route of exposure incidental to proper handling.

INHALATION: Remove to fresh air if effects occur. Consult a physician.

NOTE TO PHYSICIAN: If burn is present, treat as any thermal burn, after decontamination. No specific antidote. Supportive care. Treatment based on judgement of the physician in response to reactions of patient.

PROTECT PEOPLE: Coins may present a slipping hazard.

PROTECT THE ENVIRONMENT: Spills should be collected to prevent contamination of waterways.

CLEANUP: Sweep or vacuum up material and place in container.

DISPOSAL: Do not dump into any sewers, on the ground, or into any body of water. All disposal methods must be in compliance with all Federal, State/Provincial and local laws and regulations. Regulations may vary in different locations. Waste characterizations and compliance with applicable laws are the responsibility solely of the waste generator. The Ortho Kinetics Corporation has no control over the management practices of parties handling or using this material. The information presented here pertains only to the product described in MSDS Section 2.

For unused & uncontaminated product, the preferred options include sending to a licensed, permitted: recycler, reclaimer, incinerator or other thermal destruction device, or landfill.

UNITED STATES DOT INFORMATION:

This product is not regulated by D.O.T. when shipped domestically by land.

CANADIAN TDG INFORMATION:

This product is not regulated by TDG when shipped domestically by land.

NOTICE: The information herein is presented in good faith and believed to be accurate as of the effective date shown above. However, no warranty, express or implied is given. Regulatory requirements are subject to change and may differ from location to another; it is the buyer’s responsibility to ensure that its activities comply with federal, state or provincial, and local laws. The following specific information is made for the purpose of complying with numerous federal, state or provincial, and local laws and regulations. See other sections for health and safety information.

TOXIC SUBSTANCES CONTROL ACT (TSCA): All ingredients are on the TSCA inventory or are not required to be listed in the TSCA inventory.

SARA TITLE III, SECT. 313: Listed

OSHA HAZARD COMMUNICATION STANDARD: This product is not a "Hazardous Chemical" as defined by OSHA Hazard Communication Standard, 29 CFR 1910.1200.

This information is being supplied to you under OSHA "Right to Know" regulation 29 CFR 1910.1200 and is offered in good faith as typical values and not as product specification. The information is believed to be true and accurate. No warranty, expressed or implied, regarding the accuracy of this data, the hazard connected with use of the material, or results to be obtained from the use thereof, is made.

Ortho Kinetics Corporation